Melting point: Every metal has a melting point – the temperature at which the metal turns from a solid to a liquid. This property is critical in welding because, of course, you’re trying to melt metal. Tungsten has the highest melting point; you need temperatures of 6,170 degrees Fahrenheit to melt tungsten. That’s remarkably high compared to, say, tin, with a melting point of only 450 degrees Fahrenheit.
All metals have to be cleaned and prepared before you weld them, and steel is definitely no exception. Quality welds aren’t going to happen if your steel is covered with surface contaminants. And some of those contaminants can be downright dangerous to your health if they’re heated up and converted to fumes while you’re welding. (Flip to Chapter 3 to read all about the safety gear you can get to protect yourself from fumes.)
You especially need to do your best to remove rust from the surface of your steel. Rust is especially common on mild steel (covered earlier in this chapter), and it can wreak havoc when you’re trying to produce a high quality weld. The most common defect you experience as a result of rust is porosity (the presence of lots of little holes) in your welds, and porosity can really ruin a good weld joint.
You can use one of two methods for cleaning your steel prior to welding: chemical or mechanical. The method you choose depends on the metal type, the condition of the metal, the welding process you’re planning to use, and the equipment available.
Cleaning steel with mechanical methods
When you clean your steel mechanically, you clean the surface by scraping, brushing, or grinding. I usually clean pieces of steel by hand (without power tools) only when the pieces are very small because power tools are just faster otherwise. If you opt to clean steel by hand, I recommend using a very sturdy wire brush. (Check out Chapter 4 for information on wire brushes and other basic tools you need for welding.)
Tools powered by electricity or pressurized air have become the standard for cleaning steel in many welding shops, especially for shops that weld large pieces. The most common power tools used for cleaning steel are angle grinders, shown in Figure 2-2. An angle grinder in use is depicted in Figure 2-3.
FIGURE 2-2: A typical angle grinder.
Cleaning steel with chemicals
Chemical cleaning is, as you can probably guess, a way to clean steel by using harsh chemicals. I’m talking about some pretty rough chemicals here, so if you go the chemical cleaning route, please be sure to treat the materials with the utmost respect.
FIGURE 2-3: Cleaning steel with an angle grinder.
You can clean steel with several different chemicals, and here are a few that you may want to consider.
❯❯ Acetone: This harsh chemical removes rust and oxidation from steel. Welders usually use acetone by spraying it on and rubbing or wiping it off with a clean rag. Compared to some of the other solvents sometimes used to clean metal, acetone is relatively mild, but it’s still a toxic material, so proceed with caution.
❯❯ Alcohol: You can use alcohol for light cleaning and for degreasing. I recommend spraying it on and wiping it off with a clean rag or cloth.
❯❯ Acid: You can use sulfuric or hydrochloric acids to remove rust scales and oxidation from steel before welding it. These substances are dangerous, so use extreme caution if you go this route – in fact, I recommend cleaning with acid only as a last resort. After applying the acid, make sure you rinse the area thoroughly with hot water and dry it as soon as possible.
You can weld steel with just about any of the welding methods I describe in this book, but I recommend sticking with the big three arc welding techniques – stick, mig, and tig. Here’s a quick look at a few steel welding specifics to keep in mind for each of those processes.
Stick welding
Stick welding works just fine for joining steel. It’s extremely portable – which comes in handy when you need to weld a huge piece of steel that you can’t easily move – and as you can read in Chapters 5 and
