button.
2. Check or uncheck the Tools you want to remove or add from the menu.
3. Left click in the main drawing area to close the menu.
Note: The Tools on the Status Bar may change depending on whether you are in Model Space or Paper Space.
A brief description of each Tool will be shown on the next five pages. Each Tool will be discussed in more detail in future lessons.
Status Bar Tool Button Descriptions
I have enabled all the Tool buttons and broken them down into two sections starting from the left-hand side.
Coordinates
The coordinates display the location of the cursor in reference to the Origin. The Origin is currently in the lower left corner of the drawing area. These numbers will change as you move the cursor.
First set of numbers represents the horizontal movement of the cursor (X axis).
Second set of numbers represents the vertical movement of the cursor (Y axis).
Third set of numbers represents the Z axis which is used for 3D and not discussed.
Model
The Model / Paper button allows you to work in either model space or paper space without leaving the Layout Tab. When you switch to a Layout Tab this button automatically switches to Paper.
Grid
The criss-cross lines in the Drawing Area are called the Grid. It is only a drawing aid and will not print. The default spacing is 1 unit of measurement. You may change the Grid spacing at any time by typing DS then press <enter>, then select the Snap and Grid tab from the Drafting Settings dialog box.
Snap Mode
Increment Snap controls the incremental movement of the cursor. If it is on the cursor will "snap” in an incremental movement. If it is off the cursor will move smoothly. You may set the increments by clicking on the down
You can also choose whether to use Grid Snap or Polar Snap on the same menu.
Infer Constraints
Inferred Geometric Constraints automatically applies coincident constraints for Endpoint, Midpoint, Center, Node, and Insertion Object Snaps.
Dynamic Input
When Dynamic Input is on, you can enter coordinate values in tooltips near the cursor. More on this in Lesson 11.
Ortho Mode
Ortho restricts the movement of the cursor to Horizontal or Vertical. When Ortho is on the cursor moves only in the horizontally or vertically. When Ortho is off the cursor moves freely in any direction.
Polar Tracking
Polar Tracking restricts cursor movement to specified increments along a polar angle. More on this in Lesson 11.
You may set the increments by clicking on the down
Isometric Drafting
Isometric drawing allows you to simulate a 3D object by aligning along 3 axes, these are Top, Right and Left, called Isoplanes. When the button is enabled you can toggle the Isoplanes by pressing the F5 key. Isometric Drafting is discussed in the Advanced AutoCAD® Exercise 2018 Workbook.
You may also change Isoplanes by clicking the down
Object Snap Tracking
Object Snap Tracking controls the display of Object Snap reference lines, AutoSnap marker, tooltip and magnet.
2D Object Snap
When 2D Object Snap is on the cursor will "snap” to preset locations on 2D objects. More on this in Lesson 4.
You may also add or remove Object Snaps by clicking the down
Lineweight
