settings to match the settings shown below.
7.Select the Symbols and Arrows tab and change your setting to match the settings shown below.
8.Select the Text tab and change your settings to match the settings shown below
9.Select the Fit tab and change your setting to match the settings shown below.
10.Now select the OK button.
Your new style “DIM-DECIMAL” should be listed.
11.Select the “Set Current” button to make your new style “DIM-DECIMAL” the style
12.Select the Close button.
13.Important: Re-Save your drawing as My Decimal Setup.
Now you will select the printer and the paper size to use for printing.
You will use the Layout1 tab (Paper space).
A.Open My Decimal Setup (If not already open)
B.Select Layout1 tab.
Note: If the “Page Setup Manager” dialog box shown below does not appear automatically, right click on the Layout tab and select Page Setup Manager.
C.Select the New... button.
D.Select the <Default output device> in the Start with: list.
E.Enter the New page setup name: Setup A
F.Select OK button.
(I am assuming that your computer is attached to a printer. If not select Layout1)
This is where you will select the print device, paper size and the plot offset.
G.Select the Printer / Plotter
Note: Your current system printer should already be displayed here. If you prefer another select the down arrow and select from the list. If the preferred printer is not in the list you must configure the printer. Refer to Appendix-A)
H.Select the Paper Size
I. Select Plot Offset
J. Select OK button.
K.Select Setup A.
L.Select the Set Current button.
M.Select the Close button.
You should now have a sheet of paper displayed on the screen.This sheet is the size you specified in the “Page Setup”.This sheet is in front of Model Space.
Rename the Layout tab
N.Right click on the Layout1 tab and select Rename from the list.
O.Enter the New Layout name A Size
P.Very important: Save as My Decimal Setup again.
Q.Continue on to Exercise 3C.....you are not done yet.
CREATE A BORDER AND TITLE BLOCK
A.Draw the border rectangle as large as you can within the dashed lines approximately as shown below using layer Border,
B.Draw the Title Block as shown using:
1.Layers Border and Text
2.Multiline Text; Justify Middle Center in each rectangular area.
3.Text Style= Text-Classic Text height = varies.
C.Very important: Save as My Decimal Setup again.
D.Continue on to Exercise 3D.....you are not done yet.
The following instructions will guide you through creating a VIEWPORT in the Border Layout sheet. Creating a viewport has the same effect as cutting a hole in the sheet of paper. You will be able to see through the viewport frame (hole) to Modelspace.
A.Open My Decimal Setup (If not already open)
B.Select the A Size tab.
C.Select layer Viewport
D.Type: MV <enter>
E.Draw a Single viewport approximately as shown. (Turn off OSNAP)
