button.
D. Select the <Default output device> in the Start with: list.
E. Enter the New page setup name: Setup B
F. Select OK button.
This is where you will select the print device, paper size and the plot offset.
G. Select the Printer / Plotter
Note: Your current system printer should already be displayed here. If you prefer another select the down arrow and select from the list. If the preferred printer is not in the list you must configure the printer. (Refer to Appendix-A for instructions.
H. Select the Paper Size
I. Select Plot Offset
J. Select OK button.
K. Select Setup B.
L. Select the Set Current button.
M. Select the Close button.
You should now have a sheet of paper displayed on the screen.
This sheet is the size you specified in the “Page Setup”.
This sheet is in front of Model Space.
Rename the Layout tab
N. Right click on the Layout1 tab and select Rename from the list.
O. Enter the New Layout name A Size
P. Very important: Save as My Feet-Inches Setup again.
Q. Continue on to Exercise 4C....you are not done yet.
CREATE A BORDER AND TITLE BLOCK
A. Draw the Border rectangle as large as you can within the dashed lines approximately as shown below using Layer Border.
B. Draw the Title Block as shown using:
1. Layers Border and Text.
2. Single Line Text ; Justify Middle in each rectangular area. (Hint: Draw diagonal lines to find the middle of each area, as shown)
3. Text Style = Text-Classic Text height varies.
C. Very important: Save as My Feet-Inches Setup again.
D. Continue on to Exercise 4D.....you are not done yet.
The following instructions will guide you through creating a VIEWPORT in the Border Layout sheet. Creating a viewport has the same effect as cutting a hole in the sheet of paper. You will be able to see through the viewport frame (hole) to Model Space.
A. Open My Feet-Inches Setup (If not already open).
B. Select the A Size tab.
C. Change Current layer to: Viewport
D. Type: MV <enter>
E. Draw a Single viewport approximately as shown. (Turn off OSNAP temporarily.)
F. Adjust the Viewport Scale as follows:
F1. Confirm Model button showing.
F2. Select Zoom / All
F3. Select the Viewport Scale of 1/4” = 1’-0 (Note: inches = feet)
G. Lock the Viewport.
H. Very important.... Save as My Feet-Inches Setup again.
I. Continue on to Exercise 4E....you are not done yet.
The following instructions will guide you through the final steps for setting up the master template for plotting. These settings will stay with My Feet-Inches Setup and you will be able to use it over and over again.
In this exercise you will take a short cut by importing the Plot Setup A from My Decimal Setup.dwt. (Note: If the Printer, Paper size and Plot Scale is the same you can use the same Page Setup.)
Note: If you prefer not to use Import, you may go to 3-19 and follow the instructions for creating the Plot- page setup.
A. Open My Feet-Inches Setup
B. Select the A Size layout tab.
You should be seeing your Border and Title Block now.
C.
