Extrapolation from Instantaneous to Hourly and Daily Fluxes
A common technique for extrapolating instantaneous satellite‐based flux estimates to daily totals is to assume that the evaporative fraction (EF), given by the ratio of latent heat to the available energy, is constant during daylight hours for a given day (Gurney & Hsu, 1990; Shuttleworth et al., 1989; Sugita & Brutsaert, 1991). Given the value of EF determined at the ALEXI modeling time (t 2) along with hourly estimates of R n and G at times t i, which can be obtained from GOES, hourly values of system sensible and latent heating can be computed for days with clear mornings as (Anderson et al., 1997):
(2.7)
(2.8)
Previous studies have shown that daily total fluxes estimated using the EF measured at midday underestimate observed totals by 5–10% (Brutsaert & Sugita, 1992; Crago, 1996; Gurney & Hsu, 1990; Sugita & Brutsaert, 1991; Zhang & Lemeur, 1995), therefore EF is defined here as:
(2.9)
using flux components computed at modeling time t 2.
For clear pixels, hourly fluxes from the soil component of the two‐source system are obtained as:
(2.10)
(2.11)
(2.12)
while the canopy components are determined as residuals:
(2.13)
(2.14)
Hourly E Ci and E Si are integrated to provide the daily total water extractions 〈E C〉 and 〈E S〉 used to update the root zone and soil surface moisture pools.
For cloudy pixels, hourly values of latent heat flux are simply estimated from hourly potential evapotranspiration PET i and contemporaneous stress function values, while sensible heat is computed as a residual to the component energy budget:
(2.15)
(2.16)
(2.17)
(2.18)
2.3.3. Potential Evapotranspiration
The ratio of actual ET to PET (ET/PET) requires the computation of a value for PET. Potential ET is the amount of ET that would occur under optimal conditions over a surface that is at or above field capacity. There are several documented methods that can estimate the value of PET; some are more complicated, such as the PM method, while others, such as the PT approximation, are much simpler. The PT method was chosen to be used within the ALEXI modeling framework because of its relative simplicity and its need for a minimum amount of ancillary data sources. The computation of PET is handled separately between the vegetated and bare soil components of each ALEXI grid cell, and this is done by the partitioning of two equations with respect to the fraction of vegetation cover. Potential canopy transpiration using the PT approximation can be computed by
(2.19)
Potential soil evaporation is also estimated with a modified PT approximation documented by Tanner and Jury (1976).
(2.20)
(2.21)
where τ is the canopy transmission factor, γ is the psychometric constant (0.067 kPa °C‐1), S is the differential of the saturation vapor pressure versus temperature curve, ϕ s is the solar zenith angle, f c is the fraction of vegetation cover and R n is the net radiation for both soil and canopy components. The value of α c is held constant at 1.3, but the value of α s is a function of the following expressions with a critical value τ crit equal to 1.5, when τ is less than the critical value α s is equal to 1. If τ is greater than the critical value, then α s can be computed by
(2.22)
where α p = 1.3.
Although the ALEXI model estimates the contribution of direct soil evaporation and canopy transpiration separately, partitioned by the percent of vegetation cover, in this study we use only the system (direct soil evaporation + canopy transpiration) actual ET and PET estimates. At present, the system f PET from the ALEXI model appears to be more robust than do the component’s f PET values, perhaps reflecting errors in the model partitioning of fluxes between the soil and canopy. Qualitative analyses show a large degree of noise in the direct soil evaporation fields, while the canopy transpiration fields tend to exhibit little variability. The total system (direct soil evaporation + canopy transpiration) estimates exhibit far less noise and in essence represent an estimate of a fraction of actual ET to PET. It appears that there is no degradation in quality when using the total system ET fields when comparing the two separate fields of direct soil evaporation and canopy transpiration. The contribution of canopy transpiration compared to that of direct soil evaporation is heavily dependent on several variables: the percent of vegetation cover, vegetation type, and days since the last rainfall. It has been observed that the first few centimeters of the soil profile can dry very quickly after rainfall. Its hydraulic conductivity with the root‐zone is significantly reduced and the two layers become decoupled, and direct soil evaporation ceases (Anderson et al., 2005). The timescale of drying within the root zone is substantially longer than that of the surface layer and plants can continue to transpire at significant rates even through long stretches with a lack of rainfall. The surface layer only represents a small percentage of available water in the soil profile, and even under relatively low percents of vegetation cover, plant transpiration is important and most likely is the dominant source of ET. The total system fraction of actual ET to PET can be expressed as
(2.23)
