Beginning AutoCAD 2015. Cheryl R. Shrock
Чтение книги онлайн.
Читать онлайн книгу Beginning AutoCAD 2015 - Cheryl R. Shrock страница 17
RECOVERING A DRAWING
In the event of a program failure or a power failure any open files should be saved automatically. (Refer to page 2-24)
When you attempt to re-open the drawing the Drawing Recovery Manager will display a list of all drawing files that were open at the time of a program or system failure. You can preview and open each .dwg or .bak file to choose which one should be saved as the primary file.
To safely exit AutoCAD follow the instructions below.
1.Save all open drawings.
2.Start the EXIT procedure using one of the following.
Ribbon = None or
Application Menu = |
|
or Keyboard = Exit <enter>
If any changes have been made to the drawing since the last Save As, the warning box shown below will appear asking if you want to SAVE THE CHANGES?
Select YES, NO or CANCEL.
INSTRUCTIONS:
1.Start a NEW file using 2015-Workbook Helper.dwt.
2.Draw the objects below using:
A.Line command
B.Ortho (F8) ON when drawing Horizontal and Vertical lines.
C.Ortho (F8) OFF when drawing lines on an Angle.
D.Turn Increment Snap (F9) ON
E.Turn Osnap (F3) OFF
F.Turn Grid (F7) ON
G.Use the Close option
3.Save the drawing as: EX2A
EXERCISE 2B
INSTRUCTIONS:
1.OPEN EX2A, if not already open.
2.Erase the missing Lines as shown.
A.Turn Osnap (F3) OFF (It will be easier to move the cursor accurately)
3.Save the drawing as: EX2B
EXERCISE 2C
INSTRUCTIONS:
1.Start a NEW file using 2015-Workbook Helper.dwt.
2.Draw the objects below using:
A.Line command
B.Ortho (F8) ON when drawing Horizontal and Vertical lines.
C.Ortho (F8) OFF when drawing lines on an Angle.
D.Turn Increment Snap (F9) ON
E.Turn Osnap (F3) OFF
F.Turn Grid (F7) ON
G.Use the Shift Key to toggle Ortho ON and OFF
3.Save the drawing as: EX2C
EXERCISE 2D
INSTRUCTIONS:
1.Start a NEW file using 2015-Workbook Helper.dwt.
2.Draw the objects below using:
A.Line command
B.Ortho (F8) ON when drawing Horizontal and Vertical lines.
C.Ortho (F8) OFF when drawing lines on an Angle.
D.Turn Increment Snap (F9) ON
E.Turn Osnap (F3) OFF
F.Turn Grid (F7) ON
G.Use the Shift Key to toggle Ortho ON and OFF
3.Save the drawing as: EX2D
LEARNING OBJECTIVES
After completing this lesson, you will be able to:
1.Create a Circle using 6 different methods
2.Create Rectangles with chamfers, fillets, width and rotation.
3.Set Grids and Increment Snap
4.Draw using Layers
5.Control Layers
6.Create Layers