drawing as: EX3A
EXERCISE 3B
INSTRUCTIONS:
1.Start a NEW file using 2015-Workbook Helper.dwt.
2.Change the Increment Snap to .20 and Grid spacing to .40
If you have the Snap and Grids set correctly it will be easy.
3.Make sure SNAP and GRID status bar buttons are ON.
4.Draw the objects below using layer Object Line. Review pages 3-2 through 3-6 for Circle and Rectangle options.
5.Do not dimension, you will learn dimensioning soon.
6.Save the drawing as: EX3B
EXERCISE 3C
INSTRUCTIONS:
1.Start a NEW file using 2015-Workbook Helper.dwt.
2.Draw the Rectangles below using the options:
Dimension, Chamfer, Fillet, Width and Rotation
3.Use layer Object Line.
4.Save the drawing as: EX3C
EXERCISE 3D
INSTRUCTIONS:
1.Start a NEW file using 2015-Workbook Helper.dwt.
2.Important, important: Draw the objects below using the following Layers:
Roof, Wall, Window, Door and Plants
3.You can change Snap and Grid settings to whatever you like.
4.You decide when to turn Ortho and Snap ON or OFF.
5.All objects must be placed accurately. All lines must intersect exactly.
6.Save the drawing as: EX3D
EXERCISE 3E
INSTRUCTIONS:
1.Open EX3D. (Use OPEN not NEW to open an existing drawing)
2.Make layer Object “current” (I am having you do that because you can’t Freeze or Lock a layer that is current and I want to make sure that none of the layers that you used in the drawing is current.)
3.Freeze the following layers: Window and Plants (Do not use erase)
4.Lock layer Roof
5.Try to erase any of the roof lines.
You can’t because the Roof layer is Locked.
6.Save the drawing as: EX3E
EXERCISE 3F
INSTRUCTIONS:
1.Start a new file using template Acad (do not select Acad3D) (Located in the Template list 3 names below your 2015-Workbook Helper template)
3.Create 3 layers named Fence, Gas and Invisible. (Refer to page 3-15) Assign the Name, Color, Linetype and Lineweight as shown above.
4.Draw the LINES below using the new layers:
A.Select the layer
B.Select the Line command
C.Draw the lines approximately 5 inches long.
D.Ortho (F8) ON.
5.Save the drawing as: EX3F
EXERCISE 3G
INSTRUCTIONS:
1.Open EX3B
2.Open the Layer Properties Manager (Refer to page 3-10)
3.Change Transparency of the Object Line layer to 70 (Refer to Page 3-14)
| 4.Select the Transparency status button to show or hide Transparency. |
|
5.Save the drawing as: EX3G
Notes:
LEARNING OBJECTIVES
After completing this lesson, you will be able to:
1.Understand
